© Copyright 2004, Creative Playthings, Printed in U.S.A.
PINNACLE ROCK WALL
19652-400 Rev F (05-20)
Page 2
ASSEMBLY INSTRUCTIONS
1'-6 1/4"
1'-9 3/4"
1"
The instructions on this page are for the installation of the Pinnacle Rock Wall to the back of a
gym with a gambrel (barn-shaped) tent only. If your gym has a hooped tent or a wooden roof,
these preparations are not necessary.
Remove Wall Slats and Back Tent Post:
If your gym is fully assembled, remove the gambrel tent
and the center tent pipe. Remove the back Tent Post and
the Wall Slats from the back wall of the gym.
Be sure to save the Tent, Pipes, Wall Slats and all of the
hardware for reassembly.
Install New Center Post:
Put the Center Tent Pipe in place. Using the 5/16 x 2-1/2"
Hex Bolt Assemblies from the original Tent Post, fasten
the Center Post (I) to the End Tent Support. Re-fasten the
Center Tent Pipe.
Use a level to make sure the Center Post is plumb. Drill
a 3/8" diameter hole through the hole in the bottom of the
Center Post and then through the Platform End. Fasten
the Center Post using one 5/16 x 3" Hex Bolt Assemblies.
Restore Wall Slats:
Evenly space three Wall Slats between each gym Corner
Post and the new Center Post. Fasten them using
the original screws. The gap between boards will be
approximately 2-1/4".
Prepare Bench Seat:
Use a saw to cut a notch to fit around the new Tent Post.
Cut the notch in the side without holes. The dimensions of
the notch are shown at right.
When fastening the Bench to the gym. Fit the notch around
the Tent Post.
Wall Slats
Center Tent
Pipe
End Platform
Support
End Tent
Support
I
Wall Slats