© Copyright 2005, Creative Playthings
LEXINGTON WITH WOOD ROOF
19686-300 Rev Q (09-20)
Page 16
ASSEMBLY INSTRUCTIONS
STEP 23 — Front Wall Slats:
Fasten three Wall Slats (U) to the front platform end and
the front end wall support, as shown. Use four #10 x 1-5/8"
screws in each wall slat. Leave approximately 2-3/4" be-
tween each wall slat. The bottom of all wall slats should be
spaced approximately 1/2" above the platform surface.Hint:
Use the Slide Mount (K) to make sure there is enough room
for the slide.
U
AC
V
D
A
O
STEP 21 — Swing Mount:
The Swing Mount (D) can be attached to any side of a gym.
One swing mount is used for a 7 Ft swing beam. No swing
mounts are needed for a 9 Ft Swing Beam.
See the instructions that come with your swing frame for the
steps required to install Swing Mounts.
STEP 22 — Safety Rail:
If you are mounting a swing beam to this gym, install the
Safety Rail (A) to keep children from walking into the swing
area. With no swings, the safety rail is not needed.
Fasten the safety rail to the corner posts on the same side
of the tower as the swings using two 5/16 x 3" lag screws
with 5/16" flat washers as shown. Use the pre-drilled holes
provided.
The following steps include instructions for installing wall slats as shown on the cover of this guide. Plan the wall slat
positions according to your layout. In general, try to provide passage wider than 15" for any event. The opening for
a slide should be 24" or wider.
It is extremely important to never leave a gap of
more than 3-1/2" unless that gap is wider than 9"
.
A gap larger than 3-1/2" might allow a child's body to
slip through leaving the child's head trapped. A head
entrapment can be deadly.
5/16 x 4"
Hex Bolts
5/16 x 3"
Lag Screws
#10 x 1-5/8"
Screws
1/2" gap
Parts have
been omitted
for clarity.
