LEXINGTON WITH WOOD ROOF
19686-300 Rev Q (09-20)
© Copyright 2005, Creative Playthings
Assembly
Page 11
ASSEMBLY INSTRUCTIONS
STEP 5 — Outside Stringers:
Mount the Outside Stringers (H) to the inside of
the front and rear corner posts using two 5/16
x 5-1/2" hex bolt assemblies as shown. Start
the hex bolt from the outside of the gym. Push
each bolt through the bottom hole in the front or
rear platform ends and the corner posts before
passing through the outside stringer.
Make sure the platform ends and outside stringers
align across the bottom edge.
Hint: The holes in the outside stringers are offset
from the center of the board; you may have to flip
the board to achieve proper alignment.
O
V
H
V
5/16 x 5-1/2"
Hex Bolts
5/16 x 4" Lag
Screws
5/16 x 2-1/2"
Hex Bolts
STEP 6 — Inside Stringers
Mount each of three Inside Stringers (G) between the plat-
form sides using two 5/16 x 4" lag screws and flat washers
as shown.
Make sure the outside stringers and inside stringers align
across top edges.
G
V
O
O
STEP 7 — Angle Braces:
Fasten an Angle Brace (B) to each end of both platform sides
using four 5/16 x 2-1/2" hex bolt assemblies. Do not tighten
yet. Fasten each angle brace so the angled end is flat against
the nearest corner post.
Fasten an Angle Brace (B) to each end of the platform ends
using four 5/16 x 2-1/2" hex bolt assemblies. Do not tighten
yet. Align each angle brace so the angled end is flat against
the nearest corner post.
B
O
O
V
B
V
Platform Side
Omitted for
Clarity
Move the tower to the final intended postion. Use a carpenter's level to assure the base is level and the
posts are plumb.
