LEXINGTON WITH WOOD ROOF
19686-300 Rev Q (09-20)
© Copyright 2005, Creative Playthings
Assembly
Page 13
ASSEMBLY INSTRUCTIONS
P
O
P
O
AC
AA
V
STEP 11 — Side Wall Supports:
Fasten one Side Wall Support (P) to the corner posts above the left platform side using four 5/16 x 4" hex bolt assemblies.
Fasten the other side wall support to the corner posts above the right platform side in the same way.
STEP 12 — Front End Wall Support:
Fasten the front End Wall Support (AC) to the corner posts
above the front platform end using four 5/16 x 4" hex bolt
assemblies. Leave off the back wall support for access when
lifting the roof panels into place.
Roof Rafter
Roof Rafter
Corner
Corner
Post
Post
STEP 13 — Roof:
Note: The hardware to attach the Roof Assembly can be
found in the roof box.
The Roof Panels (AA) are heavy; be
sure to have adequate assistance to position and fasten
each side.
Position the roof panels on the corner posts with the holes at
the top of the Corner Posts aligned with the holes in the roof
rafters. The angled end of the roof rafter should be on the
inside of the play set. Fasten each roof panel to the corner
posts using two 5/16 x 4-1/2" hex bolt assemblies. Do not
tighten the fasteners completely until after the next step.
5/16 x 4" Hex Bolts
5/16 x 4" Hex Bolts
5/16 x 4-1/2" Hex Bolts
