DiRECT ADAPTER FOR SPiRAL & SWOOSH SLiDES
19946-100 Rev B (07-17)
© Copyright 2017, Creative Playthings, printed in U.S.A.
page 9
Assembly instructions
K
View from below
Top
step 8 — bottom slide support
Locate the Bottom Slide Support (K), and align with the
bottom of the gym where the Direct Adapter for Spiral &
Swoosh Slides is installed. Measure approximately 26" from
the ground to the top edge of the Bottom Slide Support.
Make sure the ends of the Bottom Slide Support are flush
with the Corner Posts. Mark the position of the countersunk
holes onto the two Corner Posts. Drill a 3/8" hole through
each Corner Post at the marks made. Fasten the Bottom
Slide Support to the Corner Posts using two 5/16 x 4" Hex
Bolt Assemblies.
Note: if the Spiral Slide Direct Adapter is installed on a
gym with a Clubhouse Bottom Enclosure, the Bottom Slide
Support is unnecessary. The Lower Slide Support Bracket
in the following step should be fastened to the 2 x 3 framing
that runs below the window on the Clubhouse Window Wall
Panel. The attachment should be made with two 5/16 x 2"
Lag Screws and two 5/16" Flat Washers. The Lag Screws
are not included.
step 9 — install lower slide support bracket
Locate the Lower Slide Support Bracket (H).
On the Outlet Section of the Slide, mount the Lower Slide
Support Bracket at the closest distance to the holes in the
Bottom Slide Support. Remove two Hex Bolt Assemblies (in
this case, a Hex Bolt Assembly consists of one Hex Bolt, two
Flat Washers and one Lock Nut) and install the Lower Slide
Support Bracket by re-attaching the two Hex Bolt Assemblies
through the holes on the Outlet Section. Secure the Bracket
to the Bottom Slide Support using two 5/16 x 1-1/2" Hex
Bolt Assemblies (One Hex Bolt, one Lock Washer, one Flat
Washer and one Weld Nut).
Note: Make sure the orientation of the bracket is correct, the
flat surface should face up. (See illustration)
26"
