Assembly instructions
© Copyright 2017, Creative Playthings, printed in U.S.A.
DiRECT ADAPTER FOR SPiRAL & SWOOSH SLiDES
19946-100 Rev B (07-17)
page 10
Anchor Nail
5/16 x 12"
Ground Level
Anchor Nail
5/16 x 12"
step 10 — Anchoring run-off section
Drill two 5/16" holes through each side of the lower flange on
the Run-off Section.
Hammer the two Anchor Nails into the ground to anchor the
front of the Spiral Slide.
NOTE: The Anchor Nails will hold better if they are driven in
at a slight angle as shown in the illustration.
step 11 — hole caps:
Make a final check and make sure that all the bolts and
screws have been tightened.
Locate the 1" Hole Caps in the hardware bag. install Hole
Caps into all the counter-bored holes to cover and protect
the hardware.
45"
Gym Base Extension
3/8" dia.
Do not mount a 9 foot swing beam to the same end of the Gym as a spiral slide Direct connect.
mounting a 9 ft. swing beam to the same end of the gym as the swoosh slide Direct connect requires two parts of
the 9 foot beam Assembly to be altered as shown in the following steps.
special instructions for 9ft swing beam brace
step 1 — cut & Drill the Gym base extension
Use a saw to cut the Gym Base Extension to 45". Be careful
to cut off the end with holes that are square to each other.
Place the off-cut piece even with the cut end of the board and
mark the hole positions on the Gym Base Extension. See the
illustration at right.
Drill 3/8" diameter holes through the board at the marks.
