Assembly instructions
© Copyright 2017, Creative Playthings, printed in U.S.A.
DiRECT ADAPTER FOR SPiRAL & SWOOSH SLiDES
19946-100 Rev B (07-17)
page 6
step 10 — hand Grips
Drill two 3/16" diameter pilot holes 1-1/2" deep into each
Ladder Rail as shown. One hole at 14-1/2" from the top of
each Rail and the other at 23-1/2" from the top of each Rail.
Fasten the two Hand Grips (Y) to the Side Rails using two
1/4 x 1-1/2" Lag Screws and two 1/4" Flat Washers each.
Use C-wrench or 7/16" ratcheting box wrench; a drill-driver is
likely to scar the painted surface of the Hand Grip.
Lift the top of the Swoosh Slide and place it on the Platform.
Swing the base of the slide so that the slide is square with the
Gym. A plastic slide mount is not necessary for installation.
Pull the slide tight against the Ladder Platform.
Drill 5/16" diameter holes in the center of the two outside
indents at the top of the slide. Before drilling make sure
that the holes will not encounter obstructions on the Ladder
Platform. Fasten the Swoosh Slide using two 1/4 x 1" Truss
Head Bolts from the top and two 1/4" Weld Nuts from below.
swoosh slide Assembly
step 9 — platform boards
Fasten one Platform Board (L) to the Wall Support and
Platform Sides using four #8 x 1-5/8" Screws. Align the edge
of the Platform Board to the outer edge of the Wall Support.
Fasten the Deck Slat (J) and the remaining Platform Board
to the Platform Sides using #8 x 1-5/8" Screws each. The
Boards should be tight against each other.
L
J
Y
Align these
edges
1-5/8" Screws
1/4 x 1-1/2"
Lag Screw
No Gap
14-1/2"
23-1/4"
