Assembly instructions
© Copyright 2017, Creative Playthings, printed in U.S.A.
DiRECT ADAPTER FOR SPiRAL & SWOOSH SLiDES
19946-100 Rev B (07-17)
page 4
note:
it is recommended
that two people perform
this step.
step 5 — install wall slats
Locate the two Long Slats (X). Center each Slat between a
Corner Post and Side Support. Fasten using six #8 x 1-5/8"
Screws each.
Fasten three Short Wall Slats (M) spaced evenly between
the Side Supports using four #8 x 1-5/8" Screws each.
step 4 — install Adapter components
Spiral Slide Only: remove the Mounting Plate and set it aside
for later use.
All Assemblies: secure the Top Support (N) using two #8 x
2-1/2" screws through the holes at the corners, as shown.
Make sure the holes for the Hex Bolt Assemblies align
properly between the Top Support and the Side Supports.
Rest each Bottom Side Filler (W) on top of the Wall Support
as shown. Secure each using four #8 x 2-1/2" Screw.
Place one Top Wall Support (V) as shown. Mark the position
of the counter-bored hole on the adjacent Corner Post. The
mark should be 3-1/2" above the hole below. Drill through
the Post using a 3/8" diameter drill. Fasten the Top Wall
Support to the Post using one 5/16 x 4" Hex Bolt. Fasten to
the Side Support using two #8 x 2-1/2" Screws. Repeat with
the remaining Wall Top on the other side.
Fasten the Side Fillers (U) to the Side Supports using four #8
x 2-1/2" Screws each as shown.
step 3 — install Adapter
Carefully raise the Adapter up to the gym tower platform,
lean it against the Roof Rafters and make sure the Wall
Support (O) is flush with the Corner Posts, as shown. Use
a level to make sure the Wall Support is level and the Side
Supports are plumb.
At the top of the Adapter, mark the position of the countersunk
holes onto the Roof Rafters and drill two 3/8" diameter holes
through the Rafters. Fasten the Adapter to the Rafters using
two 5/16 x 4" Hex Bolt Assemblies.
On the both ends of the Wall Support, mark the position of
the countersunk holes onto the Corner Posts and drill 3/8"
diameter holes through the Corner Posts. Fasten the Wall
Support to the Corner Posts using four 5/16 x 4" Hex Bolt
Assemblies.
Mark the positions of the holes on the bottom of the Side
Supports to the Platform Support. Drill 3/8" diameter holes
through the marks made. Fasten the Side Posts to the Platform
Support using two 5/16 x 4-1/2" Hex Bolt Assemblies.
M
X
V
W
U
N
4" Hex Bolt
1-5/8" Screws
2-1/2"
Screws
3-1/2"
4" Hex Bolt
4-1/2" Hex Bolt
Side Support
4" Hex Bolt
O
Parts omitted
for clarity
