U ser Manual
TB8H
Page 13
C O PYRIG H T ©2016 C reatC omm Technology
6.
N et port for connecting to the host
TB8H has 1 RJ45 ports, and it is marked with “PO E” separately. In the bridge mode,
please connect the device with the PO E power adaptor in the following way:
1)
Remove the bottom cover from the TB8H device, and you will see there is 1 RJ45
ports marked with “PO E”.
2)
U sing an Ethernet cable to connect the PO E power adaptor and the “PO E” port of
the TB8H device.
3)
C onnect the PO E adaptor to the normal power supply board.
4)
N ormally, “LAN ” port of the Power Adaptor can be connected to IP C amera and
other devices.
5)
Mount the TB8H securely to the pole by locking the strap tightly.
2.2
R estore to the Factory S ettings
In some cases, uses can restore the device to the factory settings. Push the reset button
for 5~10 seconds until all LED is on. This will restore to the factory setting. During this
process, the TB8H ’s RJ45 ports will be connected and disconnected twice.
For default, all the factory settings are shown in the following Table 5.
Table 2-1 Main parameters at the factory settings
Items
Default S ettings
IP address
192.168.1.36
U ser name
admin
Password
admin
W ireless mode
Access Point
2G S S ID
AP_2G
5G S S ID
AP_5G
O utput power
H igh
Encryption
W PA->W PA2->C C MP->Password
：
1234567890abc
N etwork mode
Bridge Mode
3
Q uick C onfiguration
