Software
1.If your machines are equiped with different diameter nozzle (default
0.4mm). You have to setting:
Expert-open expert setting... Nozzle size (same to yours)
Basic-Quality-Extrusion width (same to yours)
2.Small objects need lower hotend temperature around 190~200°C.
Large objects better to use Support-Raft. Easy to stick when start
printing.Easy to remove when finish printing.
Using skills
- 36 -
- 37 -
1.Better to use printed spool holders. Accroading to curl direction of
filament, Get filament through guide tube can prevent winding filament.
2.After preheating nozzle, Sharpen and straighten filament head is
necessary. This will get filament through extruder easily.
3.if you can’t send filament through nozzle well, remove pressure nut and
pressure spring first. Then open pressure arm and clear filament scrap. Sight
guide hole and send filament well.
4.Tighten pressure nut. (twist pressure nut 8~12 times after nut touch
spring. Neither too loose,nor too tight)
5. Extrude filament for a while and pull out quickly when you change
filament. Otherwise, filament may block inside heatbreak. Or choose “
Change Filament” on touch screen.
Use the small stick to poke filament out if there are filament scrap block
inside heatbreak or nozzle.
Installation section
Using skills
2
1
3
5
4
1
3
4
5
