Page 9 of 62
SERVICE NOTE
Battery Backup
The battery backup is used to maintain the date and time in case of power
interruptions or any time the main power is off.
PLACING THE VENDER ON LOCATION
!! CAUTION !!
DO NOT TRANSPORT THE VENDER TO OR FROM THE LOCATION LOADED WITH
PRODUCT OR DAMAGE TO THE VENDER MAY RESULT.
The Vender is intended for INDOOR USE ONLY. It should be kept out of direct sunlight and away from any heat
source. This Machine is not suitable for installation in an area where a water jet or hose and nozzle may be used.
The Vender must be on a solid, flat and level surface. Ensure the flooring can bear the weight load of a fully loaded
Vender (approximately
1109
lbs. or 503 kg). The Vender must be positioned close enough to an electrical outlet
so that an extension cord is not required. If the Machine will be subject to user misuse or vandalism, it is
recommended that the Vender be secured to the floor or wall as described in Crane Merchandising Systems
Technical Bulletin 344. Due to the large size and weight of the Vender, never attempt to move the Vender with a
Hand Truck or Stair Climber. Use a pallet jack or Vender/Cooler Dollies at all times when moving the Vender. The
Vender should never be slid or pushed in place. Never side load the leveling legs; doing so will cause damage to
the legs. Do not transport the Vender to or from customer locations loaded with product, as damage may result
due to excessive weight. Be sure to test Vender for proper operation before putting in to service on location. Call
the Crane Merchandising Systems Technical Service Department or your Crane Merchandising Systems
Representative for assistance.
ACCEPTABLE
AMBIENT OPERATING TEMPERATURE RANGE
Coca-Cola BevMax Refresh 4 equipment manufactured by Crane Merchandising Systems is designed to work
properly in a temperature range of 75°F to 90°F (23°C to 32°C) in 65% R.H.
LEVEL THE VENDER
Adjust the front leveling legs, ensuring that an even gap exists between the glass door and the top security angle
and receiver box, and then level the Machine front to rear. A carpenter’s level will help verify that the Vender is
level. Leveling legs are adjusted using a wrench or socket 1 ½” or 38 mm in size. If the Vender is to be used in a
bank of equipment, check the top and sides for proper alignment. If you are unable to properly level the Vender,
select an alternate location. NEVER PLACE OBJECTS UNDER THE LEVELING LEGS OF THE VENDER.
Содержание BevMAX Refresh 4 3800-4
