Crane 787E, Руководство по настройке и эксплуатации

Страница: 44 / 53

Snack / Refreshment Center Setup and Operator's Guide
Page 38 April, 1999 1670001
1. Make sure all product pushers are in the vending position.
2. Close the gum and mint assembly lid.
3. Hold the loop on the right side of the magazine with your left
hand. Release the hook with your right hand and lower
the magazine.
4. Continue to hold the loop until the magazine has been
fully lowered.
5. Pivot the gum and mint assembly back to the vending
position.
LOOP
HOOK
LOCKING
TAB
COLUMN
REDUCER
SLOT
The two left-most vending columns (as seen from the loading side) can be adjusted for two different
widths.
When a column reducer is in place, the width of the column will be 3
1
/
16
inches.
When a column reducer is removed, the width of the column will be 3
7
/
8
inches.
TO REMOVE A COLUMN REDUCER:
1. Pull the reducer away from the cabinet door to disengage the locking tabs.
2. Lift up to remove the reducer from the gum and mint assembly.
TO INSTALL A COLUMN REDUCER:
1. Place the reducer on the gum and mint dispenser so the
locking tabs are in the slots.
2. Push the reducer toward the cabinet door to lock the re-
ducer in place.
RB&&'$-)%,&-4$&P)+&1,8&5*,-&E*.0$,.$%&*,&-4$&M$,8*,D&!".*-*",
'$+"C*,D& 1,8& 9,.-177*,D& 6"7)+,& '$8)2$%.