Crane Merchandising Systems Merchant 180, Руководство оператора

Страница: 26 / 170

Initial Setup Merchant™ Operators’ Guide
January 2008 18 1810006
PRONGS
SPIRAL
COUPLER
PULL
GEAR
SPIRAL
COUPLER
BACKWALL
OF TRAY
˜
SPIRAL
MOTOR
Removing a Spiral Coupler
1. Pinch together the prongs on the end of the
spiral coupler as shown.
2. Pull the coupler forward in the direction of
the arrow as shown.
Removing and Installing a Spiral Motor
REMOVING A SPIRAL MOTOR
NOTE
Some steps may already be completed.
1. Remove the tray.
(See “Removing Trays” on page 13) .
2. Disconnect the motor harness.
(See “Connecting and Disconnecting a Motor
Harness” on page 15 ).
3. Remove the spiral.
(See “Removing and Installing Spirals” on
page 16 ).
4. Remove the spiral coupler.
(See “Removing a Spiral Coupler” on page 18 ).
5. Lift the motor clear of the tray.
6. Return the tray to the merchandiser.
(See “Installing Trays in the Merchandiser” on page 23).
INSTALLING A SPIRAL MOTOR
1. Remove the tray.
(See “Removing Trays” on page 13).
2. Place the motor in the correct position at the rear of
the tray as shown.
3. Place a gear in position if required by this set-up.
(See “Installing a Gear” on page 19).
4. Install a spiral coupler in the proper orientation.
(See “Installing a Spiral Coupler” on page 20).
5. Connect the motor harness.
(See “Connecting and Disconnecting a Motor Harness” on page 15).
6. Return the tray to the merchandiser.
(See “Installing Trays in the Merchandiser” on page 23).