12
The Edit entry warns you if the number entered is incorrect.
IP address entry is from 0 to 255
Port entry is from 0 to 65353
It shows the Status for up to 5 connected Wrenches.
Note: Info on Port 80 can be viewed at the same time as the measurement results are being transmitted to
Port 4545.
Each column shows different information:
•
Wrench Status – gives colour coded information about the current state of the WrenchStar Multi.
The key for colours is shown at the bottom of the Page. These colours will match the Wrench Status
LED on the TCI.
o
Note: The Out of Range – Yellow colour may also be seen if the WrenchStar Multi is turned
off. This colour is only seen once a WrenchStar Multi is Paired as it is then regularly polled to
check if it’s present and has any off-line results.
o
The Red/Blue colour on the TCI indicates that you will see Wrench Status LED flashing
between Red and Blue.
•
The Protocol Status – gives colour coded information about the current state of the host connection.
The key for colours is shown at the bottom of the screenshot above. These colours will match the host
Status LED on the TCI.
o
“Bad message” is an unrecognised host message
TCI WRENCH STATUS
