Cranborne THI 10-50c, Инструкция по установке, наладке и обслуживанию

Страница: 37 / 66

- 38 -
V - SETTINGS OF THE INSTALLATION TYPES
The outside sensor is necessary and
must be connected to the LMU (terminal
X10-06).
The QAA 73 room sensor is required to
access the settings and to adjust them
(§ 3 - page 43).
The boiler’s standard setup is used for the connec-
tion of:
- a Radiator circuit (CC1) controlled by the boi-
ler’s LMU,
- an Under-floor heating circuit (CC2) by using the
clip-in 2nd circuit kit.
1 - SINGLE CIRCUIT
Note :
- In the case of a single circuit (CC1) either a radia-
tor circuit or an under floor heating circuit
- However if the boiler directly supplies an under
floor heating circuit :
• The QAA 73 settings need changing in accor-
dance with the table above.
• For recommendations refer to section § 5.3 -
page 34 - chapter IV - INSTALLATION.
!
LMU
Q2
Q
VS
BS
QAD 36
QAC 34
TKS
QAA 73*
B3
CC 1
THI-
76
-0
CIR
Fig. 39
FACTORY SETTINGS QAA73 SETTINGS TO CHANGE QAA73
Function Radiator circuit (CC1)
Under-floor heating circuit
(CC1)
For operation as a pump relay or
hydraulic decoupler
line QAA73 Value line QAA73 Value Value
Slope 70 15 70 8 -
Tmax 72 80°C 72 50°C -
Parallel shift 73 0 73 0 -
Room influence 75 CC1 75 CC1 -
HydrSystem 552 51 - - 3
KonfigEingang R 618 0 - - 6
KonfigAusgang 1R 619 10 - - 8