Craftsman CMEPW2400, Инструкция по эксплуатации

Страница: 6 / 36

English
4
A .........................amperes
W ........................watts
or AC ...........alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
no .......................no load speed
n .........................rated speed
......................earthing terminal
.....................safety alert symbol
.....................visible radiation
..................... avoid staring at
light
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
IPXX .................... IP symbol
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Intended Use
This pressure washer is intended for cleaning boats, cars,
decks, driveways, grills, house siding, motorcycles, patios,
and outdoor furniture.
DO nOT
use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. These tools are factory tested; if
this tool does not operate, check power supply.
Assemble Frame Handle (Fig. A–C)
Your pressure washer is not fully assembled in the carton.
1. To assemble the frame handle 14 to the pressure
washer unit 7 , line the upper poles 15 with the lower
poles 16 so the detent pins snap into position.
Fig. B 15
16
Fig. C
14
7
Specifications
Maximum Pounds per Square Inch 2,400
Rated Gallons per Minute* 1.1
Electrical Requirements 120V
AC
~60Hz, 13A
Electrical Cord 35 ft. (10.6 m)
High Pressure Hose 25 ft. (7.6 m)
Minimum Amp Source 15A
Pressure of Inlet Water* 20-100 PSI
Inlet Water Cold Tap
Soap Consumption Rate 10% MAX
*Water flow and maximum pressure ratings determined in accordance with
CETA CPC-100.
High Pressure Hose Storage Hook (Fig. D)
Your pressure washer is not fully assembled in the carton.
1. To assemble the high pressure hose storage hook 17
to the crossmember 19 , squeeze the detent end 18 of
the hook so it will slide between the retaining slots 31
on the rear of the crossmember 19 .
2. Release the pressure hose storage hook
17
allowing the
detents 18 to rest securely in the retaining slots 31 .
3. Press the high pressure hose storage hook 17 onto the
locking detents 32 on the rear of the crossmember 19
until it clicks into place.
Fig. D
17
18
19
31
32