motor
housing
6. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin
and clip. Lower hanging ball and remove stop pin.
Then slide hanging ball off downrod. [
Refer to
diagram 1
.
]
Loosen yoke set screws and nut at top of motor
housing. [
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the
downrod. [
Refer to
diagram 2
.
]
Determine the length of downrod you wish to use.
Thread electrical wires through threaded end of
downrod and pull extra wire slack from the upper
end of the downrod. [
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--
make sure wires do not get twisted
. Re-insert
pin and clip that were previously removed. Tighten
yoke set screws and nut securely. [
Refer to
diagram 2
.
]
Slide yoke cover and canopy over downrod. [
Refer to
diagram 3
.
]
Thread wires through hanging ball and then slide
hanging ball over downrod--the top of the downrod
should be noted as having a set screw hole; use this
hole when setting the set screw. Insert stop pin into
top of downrod and raise hanging ball. Be sure stop
pin aligns with slots on the inside of the hanging
ball. Tighten set screw securely. [
Refer to
diagram 4
.
]
WARNING
: Failure to tighten set screw (on hanging
ball) completely could result in the fan becoming
loose and possibly falling.
["Fan Assembly" continued on next page.]
NOTE
: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
page 6
diagram 2
diagram 1
diagram 3
diagram 4
set screw
hanging ball
stop pin
pin
clip
canopy
set screw hole
hanging ball
stop pin
downrod
electrical wiring
pin
clip
canopy
downrod
yoke
cover
motor
housing
yoke set screw
and nut
