3. Installation Preparation.
4. Hanging Bracket Installation.
page 4
ON
OFF
ON
OFF
Vaulted ceiling
angle is not to
exceed 20 degrees.
downrod
installation
flushmount
installation
12f
t. - 20f
t.
12ft. - 20ft.
(3.66m - 6.1m)
(3.66m - 6.1m)
blade edge
7 feet
(2.13m)
(76cm)
30
inches
To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 7ft. (2.13m) from the floor and
30in. (76cm) from any wall or obstruction.
This fan is suitable for room sizes up to 400 square
feet (37.2 square meters).
This fan can be mounted with a
downrod
on a regular (no-slope) or vaulted ceiling. The
hanging length can be extended by purchasing a
longer downrod (0.5in. /1.27cm diameter). Other
installation, such as
flushmount
, is
NOT
available
for this fan.
Installation requires these tools:
Phillips screwdriver, flat-head screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape.
Turn off circuit breakers to current fixture from breaker panel
and be sure operating light switch is turned to the OFF
position.
WARNING
: Failure to disconnect power supply prior to
installation may result in serious injury.
Remove existing fixture.
WARNING
: When using an existing outlet box, be sure the outlet
box is securely attached to the building structure and can
support the full weight of the fan. Ensure outlet box is clearly
marked "Suitable for Fan Support." If not, it must be replaced
with an approved outlet box. Failure to do so can result in
serious injury.
CAUTION
: Be sure outlet box is grounded properly and that a
ground wire (
GREEN
or bare) is present.
Partially loosen screw in slotted hole on underside of canopy.
Remove the other screw--
save for later use
. Twist canopy to
remove hanging bracket.
Install hanging bracket to outlet box using original screws,
spring washers and flat washers provided with new or
original outlet box.
*
If installing on a vaulted ceiling, face
opening of hanging bracket towards high point of ceiling.
Arrange electrical wiring around the back of the hanging
bracket and away from the hanging bracket opening.
*Note
: It is very important that you use the proper hardware
when installing the hanging bracket as this will support the fan.
hanging bracket
spring washers
outlet box screws
flat washers
