hanging bracket
9. Light Kit Assembly.
Remove all 3 screws on outer edge of switch
housing. Connect
WHITE
wire from LED light kit
to
WHITE
wire from motor housing. Connect
BLACK
wire from LED light kit to
BLUE
(or
BLACK
) wire from motor housing. Be sure that
molex connections snap together completely.
Align holes in switch housing with holes in LED
light kit.
NOTE
: The gaps on the top edge of the
LED light kit must align with reverse switch and
pull chains on the switch housing for the proper
fit. Re-insert screws that were previously removed
and secure all 3 screws with a Phillips screwdriver.
Align grooves on shade with nodules on inside of
LED light kit and push up gently on shade. Twist
shade to the RIGHT (clockwise) until shade locks
into place.
Pull down VERY GENTLY on shade to
make sure that shade is secure
.
switch
housing
molex connections
motor
housing
page 8
8. Canopy Assembly.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was previously removed and
then tighten both screws securely.
screw
canopy
grooves
shade
screw
switch
housing
motor
housing
LED light kit
