page 5
Connect 3-wire plug from fan to 3-wire plug
from remote control receiver. Make sure plugs
snap together completely. (Note: 2-wire plug
will not be used).
[
Refer to
diagram 5
.
]
Pull extra wire slack from the upper end of the
downrod.
With the hanging bracket secured to the
outlet box and able to support the fan, you
are now ready to hang your fan. Grab the fan
firmly with two hands. Slide downrod
through opening in hanging bracket and let
hanging ball rest on the hanging bracket.
Turn the hanging ball slot until it lines up with
the hanging bracket tab.
WARNING
: Failure to align slot in hanging ball
with tab in hanging bracket may result in
serious injury or death.
Tip
: Seek the help of another person to hold
the stepladder in place and to help lift the fan
up to you once you are set on the ladder.
Loosen the screw and nut on safety cable
vice. Find a secure attachment point (wood
ceiling joist highly recommended) and secure
safety cable. It will be necessary to use a
heavy duty wood screw, washer and lock
washer (not supplied) with the safety cable
loop.
Adjust safety cable length by pulling on the
cable. Adjust slack in cable to a hands length
and secure vice by tightening screw and nut
securely. [
Refer to diagram 6.
] The loop at the
end of the safety cable should just fit over the
threads on the wood screw.
Test safety cable
by pulling on loose end with pliers. If the safety
cable slips, the screw and nut on the vice must
be set tighter.
Extra cable slack can be left in
ceiling area.
5. Fan Assembly. (cont.)
diagram 6
motor housing
hanging ball slot
hanging bracket tab
safety cable
safety cable loop
wood
ceiling
joist
diagram 5
3-wire plug
downrod
remote control
receiver
wood screw
and washer
vice
