page 9
9. Light Kit Assembly, 3-light Option.
Remove 3 screws from top of light kit fitter.
Locate
BLUE
(or
BLACK
) and
WHITE
wires in
switch housing labeled FOR LIGHT KIT
CONNECTION. Remove and discard plastic
that holds these 2 wires together.
Next, locate
WHITE
and
BLACK
wires in light
kit fitter labeled FOR LIGHT.
Connect
WHITE
wire from light kit fitter to
WHITE
wire from switch housing. Connect
BLACK
wire from light kit fitter to
BLUE
(or
BLACK
)
wire from switch housing. Be sure
molex connections snap together securely.
Align holes in light kit fitter with holes in
switch housing. [
NOTE
: The gap on the top
edge of the light kit fitter must align with
reverse switch on the switch housing for the
proper fit.] Attach light kit fitter with 3 screws
that were previously removed. Secure all
3 screws with a Phillips screwdriver.
Install bulbs included with light kit.
IMPORTANT
: When replacing bulbs, please
allow bulbs and shades to cool down before
touching them.
Locate slots on shade and align with nodules
on inside of light kit fitter.
Gently push up on
shade and turn
to the RIGHT (clockwise)
until
it slides completely into place.
Repeat for remaining shades.
Please proceed to Section 12 on page 12 to
complete installation.
*For Model OP104
switch
housing
motor
housing
molex
connections
light kit fitter
light kit fitter
fan pull chain
extension
switch
housing
reverse
switch
molex
connections
motor
housing
shade
light pull chain
extension
bulb
