page 6
5. Fan Assembly. (cont.)
diagram 4
Thread wires through hanging ball and then
slide hanging ball over downrod--the top of the
downrod should be noted as having a set screw
hole; use this hole when setting the set screw.
Insert stop pin into top of downrod and raise
hanging ball. Be sure stop pin aligns with slots on
the inside of the hanging ball. Tighten set screw
securely.
[
Refer to
diagram 4
.
]
Remove electrical tape from electrical wiring and
thread each of the wires through a different hole
in the weatherproof hanging ball cover. Pull
weatherproof hanging ball cover down securely
over hanging ball (on downrod).
[
Refer to
diagram 4
.
]
WARNING
: Failure to tighten set screw (on
hanging ball) completely could result in the fan
becoming loose and possibly falling.
set screw hole
set screw
hanging ball
canopy
stop pin
weatherproof
hanging
ball cover
electrical wiring
With the hanging bracket secured to the outlet box
and able to support the fan, you are now ready to
hang your fan. Grab the fan firmly with two hands.
Slide downrod through opening in hanging bracket
and let hanging ball rest on the hanging bracket.
Turn the hanging ball slot until it lines up with the
hanging bracket tab. [
Refer to
diagram 5
.
]
WARNING
: Failure to align slot in hanging ball with
tab in hanging bracket may result in serious injury
or death.
Tip:
Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you
once you are set on the ladder.
diagram 5
hanging ball slot
hanging bracket tab
motor housing
