page 5
5. Fan Assembly.
Remove hanging ball from downrod provided
by loosening set screw on hanging ball. Lower
hanging ball and remove stop pin and then
slide hanging ball off of the downrod.
[
Refer to
diagram 1
.
]
Loosen yoke set screws and nuts at top of
motor housing. Remove pin and clip from
motor housing yoke. [
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
[
Refer to
diagram 2
.
]
Determine the length of downrod you wish to
use. Thread electrical wires through threaded
end of downrod and pull extra wire slack from
the upper end of the downrod.
[
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align
with holes in yoke--
make sure wires do not get
twisted
. Re-insert pin and clip that were
previously removed. Tighten yoke set screws
and nuts securely. [
Refer to
diagram 2
.
]
Slide yoke cover and canopy over downrod.
[
Refer to
diagram 3
.
]
["Fan Assembly" continued on next page.]
NOTE
: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
set screw
hanging ball
stop pin
diagram 2
diagram 1
downrod
electrical wiring
yoke set screw
and nut
pin
motor
housing
clip
diagram 3
motor
housing
canopy
downrod
yoke cover
