page 6
6. Wiring.
7. Canopy Assembly.
CAUTION
:
Be sure outlet box is properly grounded
and that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code.
If you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to in the instructions below, please use a
qualified electrician.
Note
:
Excess lead wire length from the fan can be cut
to the desired length and then stripped.
WARNING
: If using this fan in a
WET
or
DAMP
location, this fan must be connected to a supply
circuit that is protected by a Ground Fault Circuit
Interrupter (GFCI) to reduce the risk of personal
injury, electrical shock or death.
When fan is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect
BLACK
and
BLUE
wires from fan to
BLACK
wire from ceiling with wire connector provided.
Connect
WHITE
wire from fan to
WHITE
wire from
ceiling with wire connector provided.
Connect all
GROUND
(
GREEN
) wires together from
fan to
BARE
/
GREEN
wire from ceiling with wire
connector provided.
If you intend to control the fan light with a separate
light switch connect
BLUE
wire from fan to the
BLACK
(or
RED)
supply from the independent
switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
This fan is remote control adaptable (remote
control sold separately).
Note
: Only remote controls approved for
WET
locations can be used with this fan.
Temporarily raise canopy to hanging bracket to determine
which 2 screws in hanging bracket align with
slotted
holes
in canopy, and then lower canopy and
partially loosen
these 2 screws.
Remove
the
other
2 screws and set aside.
Now, lift canopy to hanging bracket again, aligning slotted
holes in canopy with loosened screws in hanging bracket.
Twist canopy to lock. Re-insert the other 2 screws and
secure all screws with a Phillips screwdriver.
Slide canopy cover up to canopy, aligning rounded part of
slotted holes in canopy cover with screw heads in bottom
of canopy. Turn canopy cover to right (clockwise) until it
stops.
black
black
white
white
blue
black supply wire
white supply wire
from ceiling
from fan
ground
(green or bare)
*
ground
(green
or bare)
canopy
hanging bracket
slotted
holes
canopy cover
