page 4
5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower hanging
ball and remove stop pin and then slide hanging ball
off of the downrod.
[
Refer to
diagram 1
.
]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke.
[
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will keep
the wires together when threading them through
the downrod.
[
Refer to
diagram 2
.
]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod.
[
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--
make sure wires do not get twisted
. Re-insert pin
and clip that were previously removed. Tighten yoke
set screws and nuts securely.
[
Refer to
diagram 2
.
]
Locate canopy cover in hardware pack. Slide yoke
cover, canopy cover and canopy over downrod.
[
Refer to
diagram 3
.
]
(
Note
: Canopy cover must be
turned with shiny side
toward
motor housing. )
["Fan Assembly" continued on next page.]
NOTE
: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
set screw
hanging ball
stop pin
diagram 1
diagram 3
diagram 2
yoke set
screw
and nut
pin
clip
downrod
electrical wiring
safety cable
canopy
motor
housing
downrod
yoke cover
canopy cover
