page 7
7. Automated Learing Process./
Activating Code. (cont.)
Locate 4 small metal posts on the outside edge
of the mounting plate. Now, locate the 4 metal
bars on the inside of the motor housing. Raise
motor housing to mounting plate and align
the 4 metal posts on the mounting plate with
the 4 metal bars on the motor housing. Turn
motor housing
clockwise
, to the RIGHT, until it
no longer turns so that it locks.
Note
: It is extremely important that you make
sure that you turn the motor housing
all the
way to the right
to ensure that the motor
housing is completely secure.
IMPORTANT
: Store the transmitter away from excess
heat or humidity. To prevent damage to transmitter,
remove the battery if transmitter will not used for long
periods.
Restore electrical power and then set slider switch on
wall control to the ON position. Within 30 seconds of
turning on the wall control, press the fan OFF button
( ), located on the front of the transmitter, for 5
seconds or until light blinks twice. Turn power back off
and disconnect molex connections. If the light did blink
twice, please continue with "Motor Housing Assembly"
below. If light
did not
blink twice, repeat instructions in
"Wiring" section.
transmitter
(
front
)
8. Motor Housing Assembly.
Gently swing motor assembly up to mounting
plate, allowing holes on plate at top of motor
assembly to align with bolts on underside of
mounting plate. Secure motor assembly to
mounting plate with motor mounting nuts
and flat washers that were previously removed
(Section 4, Page 3). Tighten all four motor
mounting nuts securely.
motor assembly
mounting plate
motor
mounting
nuts
flat washers
mounting
plate
metal
posts
motor housing
metal
bars
Before proceeding, make sure electricity has
been
shut off
.
bolt
