ground
(green or bare)
page 5
6. Wiring.
IN ORDER TO WIRE WALL CONTROL
, remove
existing wall switch. Wire the
WALL CONTROL
with
wire connectors provided
as shown
at right.
* Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push taped
wire connectors into outlet box.
Use a ballpoint pen or a small screwdriver to set the
code switches 1 through 4 on the wall control.
Factory setting is pre-set and not recommended for
use.
Write down number sequence for use in
Section 7.
Note
: Since this fan comes with a halogen bulb, the
dimmer switch (labeled
D
and
X
) has been pre-set to
the "ON" position (
D
). If you do not wish to have
dimming capability, please move the switch to the
"OFF" position (
X
).
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front plate to
wall control using 2 screws provided in the wall
control.
green
green/
green/
bare
bare
ground
ground
green/
bare
ground
(wiring for wall control)
code
switches
wall
control
plate
outlet box
dimmer
switch
1
2
3
4
X
D
(wiring for receiver)
black (OUT to fan)
black
(AC IN from
breaker box)
black
(TO POWER supply)
black
black (OUT to fan)
black
(AC IN from
breaker box)
black
(TO POWER supply)
black
white supply wire
black supply wire
black
black
white
blue
blue
white
black
AC IN L
AC IN N
white
from fan
from receiver
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio
or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
ground (green
or bare)
antenna
from receiver
from ceiling
CAUTION:
Be sure outlet box is properly grounded
and that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National Electrical
Code. If you are unfamiliar with electrical wiring or if
the house/building wires are different colors than
those referred to in the diagram to the right, please
use a qualified electrician.
When fan is secured in place on the mounting
plate,
WIRE THE RECEIVER
with wire connectors
provided
as shown at right
.
Tip:
While you are wiring, keep in mind that wires
must not obstruct receiver from sliding into
mounting plate.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently insert receiver (flat side up) into mounting
plate and carefully push taped wire connectors
into outlet box. Let antenna rest
outside
of
mounting plate.
