Craftmade DC Epic, Руководство по установке

Страница: 6 / 22

5. Fan Assembly. (cont.)
page 5
hanging ball slot
hanging bracket tab
motor housing
safety cable
“J” hook
safety cable loop
wood
ceiling
joist
With the hanging bracket secured to the outlet box
and able to support the fan, you are now ready to hang
your fan. Grab the fan firmly with two hands. Slide
downrod through opening in hanging bracket and let
hanging ball rest on the hanging bracket. Turn the
hanging ball slot until it lines up with the hanging
bracket tab.
WARNING : Failure to align slot in hanging ball with tab
in hanging bracket may result in serious injury or
death.
Tip : Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you
once you are set on the ladder.
Replace vice on safety cable and adjust safety cable
length by pulling on the cable. Adjust slack in cable to
a hands length and secure vice by tightening screw
and nut securely. The loop at the end of the safety
cable should just fit over the “J” hook. [
Refer to
drawing at right. ]
Find a secure attachment point (wood ceiling joist
highly recommended) and secure safety cable. It will be
necessary to use the “J” hook (included) with the safety
cable loop.
Test safety cable by pulling on loose end with
pliers. If the safety cable slips, the screw and nut on the
vice must be set tighter.
6. Wiring.
WARNING: Turn off circuit breakers to current fixture from
breaker panel and be sure operating light switch is turned
to the OFF position.
CAUTION : Be sure outlet box is properly grounded and that a
ground wire ( GREEN or Bare) is present.
Make sure all electrical connections comply with Local Codes
or Ordinances and the National Electrical Code. If you are
unfamiliar with electrical wiring or if the house/building wires
are different colors than those referred to below, please use a
qualified electrician.
Note : Excess lead wire length from the fan can be cut to the
desired length and then stripped.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect
BLACK wire from fan to BLACK wire from ceiling
with wire connector provided.
Connect
WHITE wire from fan to WHITE wire from ceiling
with wire connector provided.
Connect all
GROUND ( GREEN ) wires together from fan to
BARE / GREEN wire from ceiling with wire connector
provided.
["Wiring" continued on next page.]
wire
connector
black
black
white
white
black supply wire
ground
(green
or bare)
white supply wire
from ceiling
from fan
ground
(green or bare)
*
(wiring for fan)
* Wrap each wire connector separately with electrical
tape as an extra safety measure.