page 7
8. Automated Learning Process./
Activating Code.
CAUTION
:
The remote control transmitter can be
programmed to multiple receivers or fans. If this is
not desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover from back side of remote
control transmitter.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 for the transmitter.
Use the same number sequence used when wiring
the wall control in Section 6 (page 6).
Install 9-volt battery (included) in transmitter.
Re-attach the battery cover after installing battery.
IMPORTANT
: To prevent damage to transmitter,
remove the battery if not used for long periods.
Restore electrical power and then set slider switch
on wall control to the ON position. Within 30
seconds of turning on the wall control, press and
hold the "OFF" button on the front of the
transmitter for 5 seconds. Proceed to Section 11 to
verify that the automated learning process is
complete.
TRANSMITTER
(front)
1
code
switches
pen
TRANSMITTER
(back)
battery
battery
cover
9. Wall Control Operation.
ON/OFF slider switch
- turns
wall control
ON or OFF
HI
button - turns
lower fan
to HIGH speed
MED
button - turns
lower fan
to MEDIUM speed
LOW
button - turns
lower fan
to LOW speed
FAN OFF
button - turns
lower fan
OFF
button - turns
main fan
ON/OFF when pressed
once (i.e., controls ROTATION of the
ENTIRE fan)
main
fan
lower fan
