page 4
5. Initial Fan Assembly.
NOTE
: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower hanging
ball and remove stop pin and then slide hanging
ball off of the downrod.
[
Refer to
diagram 1
.
]
Loosen yoke set screws and nuts at top of motor
assembly. Remove pin and clip from motor
assembly yoke.
[
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
[
Refer to
diagram 2
.
]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod.
[
Refer to
diagram 2
.
]
Thread downrod into the motor assembly yoke
until holes for pin and clip in downrod align with
holes in yoke--
make sure wires do not get twisted
.
Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely.
[
Refer to
diagram 2
.
]
Locate canopy cover in one of the hardware packs.
Slide yoke cover, canopy cover and canopy over
downrod.
[
Refer to
diagram 3
.
]
(
Note
: Canopy cover
must be turned with shiny side
toward
motor
assembly.)
Thread safety cable and wires through hanging ball;
then slide hanging ball over downrod--the top of
the downrod should be noted as having a set screw
hole; use this hole when setting the set screw. Insert
stop pin into top of downrod and raise hanging ball.
Be sure stop pin aligns with slots on the inside of
the hanging ball. Tighten set screw securely.
[
Refer
to
diagram 4
.
]
WARNING
: Failure to tighten set screw (on hanging
ball) completely could result in the fan becoming
loose and possibly falling.
["Fan Assembly" continued on next page.]
set screw
hanging ball
stop pin
diagram 1
diagram 3
diagram 4
diagram 2
canopy
yoke cover
downrod
yoke set screw
and nut
pin
clip
downrod
canopy cover
motor assembly
set screw hole
stop pin
hanging ball
motor assembly
safety cable
electrical wiring
