page 9
CAUTION
:
The wall and/or handheld remote control can be programmed
to multiple receivers or fans. If this is not desired, turn wall switch off to any
other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch
on wall control to the ON position. Within 60 seconds of turning on the
wall control, press and hold the fan
OFF
button on the wall control for
5 seconds (or until light blinks twice or fan blades begin to turn.)
Turn power off again for at least 5 seconds
and then turn power back
on. Within 60 seconds of restoring the power, press and hold the fan
OFF
button on the handheld remote control for 5 seconds (or until light
blinks twice or fan blades begin to turn.)
Test the light and fan functions to confirm the learning process is
complete--
see Section 13 below.
11. Automated Learning Process./Activating Code.
12. Remote Control Operation.
ON/OFF
slider switch - turns
wall control
ON or OFF
(switch not functional on handheld remote)
HIGH
button - turns
fan
to HIGH speed
MED
button - turns
fan
to MEDIUM speed
LOW
button - turns
fan
to LOW speed
OFF
button - turns
fan
OFF
L1
button - turns
light
ON/OFF when pressed once;
dims
light
when pressed and held down
L2
button -
(not applicable for this fan)
REV
button - used to REVERSE blade direction
(fan must be set on
low
before
reversing blade
direction)
13. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light switch
(if applicable). Test wall control (optional installation) by
locating ON/OFF slider switch on wall control, then set to the
ON position. Test light and dimmer function and then test
fan speeds. Next, locate handheld remote control. Test the
light ON/OFF function by pressing the L1 button; test the
dimmer function by pressing the L1 button and holding it
down for up to 5 seconds. Test fan speeds with the different
fan speed buttons. If the wall and/or handheld remote
control operate(s) all of the functions of the fan and light,
batteries have been installed correctly. If the wall and/or
handheld remote control do (does) not operate all of the
fan/light functions, refer to "Troubleshooting" section to
solve any issues before contacting Customer Service.
Fan
must
be on LOW
before
setting the fan to reverse
direction. Use the
REV
button to recirculate air depending
on the season.
NOTE
: If the wall control/handheld remote control interferes
with other appliances,
turn power off first
and then go back
to the instructions in Section 11 above.
1
1
-
2
2
-
wall control
1
1
-
2
2
-
handheld
remote control
1
1
-
2
2
-
1
1
-
2
2
-
