page 7
9. Final Fan Assembly.
Remove 1 screw from motor plate on
underside of motor assembly and
partially loosen the other 2 screws.
Align slotted holes in fitter plate
(
please note side of fitter plate with
label indicating
THIS SIDE UP
) with
loosened screws in motor plate. Twist
fitter plate to lock. Re-insert screw
that was previously removed and
securely tighten all 3 screws with a
Phillips screwdriver.
Align 3 posts inside shade with the
rounded part of the slot on outside
edge of fitter plate. Turn shade to the
RIGHT (
clockwise
) until it no longer
turns.
NOTE
: Make sure to turn shade all the
way to secure completely.
motor assembly
motor plate
fitter plate
fitter plate
shade
motor assembly
8. Blade Assembly.
WARNING
: To reduce the risk of serious
bodily injury,
DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and
break.
Time Saver
: Washers for blade screws can
be set on each blade screw prior to
installing blades.
Locate 9 blade attachment screws and
washers in hardware pack. Slide blade
through one of the narrow, rectangular
openings on motor assembly, aligning
holes in blade with holes in blade arm
(
located on the underside of the motor
assembly
)--
refer to drawing at right
. Insert
3 blade attachment screws (along with
washers) with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for each
remaining blade.
NOTE
: Tighten blade arm screws twice a
year.
blade attachment
screws and washers
blade arm
motor assembly
blade
