page 4
4. Hanging Bracket/Mounting Plate Installation. (cont.)
For FLUSHMOUNT installation,
install mounting plate to
outlet box using original screws, spring washers and flat
washers provided with new or original outlet box.* Pull
electrical wiring from outlet box through center hole in
mounting plate. Proceed to Section 6 on page 6 for
instructions on FLUSHMOUNT installation.
*Note
: It is very important that you use the proper hardware
when installing the hanging bracket/mounting plate as this
will support the fan.
5. Fan Assembly (with downrod).
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower hanging
ball and remove stop pin and then slide hanging ball
off of the downrod.
[
Refer to
diagram 1
.
]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke.
[
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the
downrod.
[
Refer to
diagram 2
.
]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod.
[
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--
make sure wires do not get twisted
. Re-insert pin
and clip that were previously removed. Tighten yoke
set screws and nuts securely.
[
Refer to
diagram 2
.
]
["Fan Assembly" continued on next page.]
diagram 2
set screw
hanging ball
stop pin
diagram 1
wiring
mounting plate
outlet box screws
flat washers
spring washers
clip
pin
downrod
safety cable
yoke set
screw
and nut
