Craftex CX505, Руководство пользователя, Страница: 8 / 24

8
ASSEMBLY
Assembling the CX505 edge belt sander is
simple and easy. To assemble the
machine, follow the instructions given
below.
STAND
Attach the side brackets to the front and
rear brackets as shown in figure-2 using
screws and washers and lock washers
provided. Do not tighten the screws.
Attach the brackets together as shown in
figure-2 using screws, washers and lock
washers provided. Make sure the stand is
sitting level on the floor from all four sides
and tighten the screws.
Figure-2 Assembling the stand
Slide the stand bottom plate from the top
into the stand assembly and install it as
shown in figure-3. Secure it to the side
brackets using two screws and two washers
provided.
Figure-3 Installing the bottom plate
INSTALLING THE SANDER
ONTO THE STAND
Once the stand is completely assembled
and all the screws are tightened properly,
use a fork lift or get the help of an assistant
and lift the sander onto the stand.
Make sure the two holes on the side of the
sander is aligned with the two holes on the
stand.
Figure-4 Installing the sander onto the
stand
Open the stand door and secure the sander
onto the stand from inside using screws,
washer and lock washers provided. See
figure-5.