Craftex CX505, Руководство пользователя, Страница: 14 / 24

14
INSTALLING / REPLACING
SANDING BELT
The CX505 comes with a 6”x 89” sanding
belt.
To install the sanding belt:
Make sure the machine is disconnected
from the power source.
Uninstall the belt guards, dust hood,
auxiliary table and the work-piece stop (if
already installed).
Figure-16 Belt guard
Set the sanding head in vertical position by
tilting the head.
Loosen the tension on the belt by loosening
the belt tension handle shown in figure-17.
Take the old belt off the drums (if already
installed) and remember the direction of
arrows printed on the belt. Install the new
belt with the direction of arrows pointing to
the same direction as the ones on old belt.
Make sure the belt is in the center of the
drums and re-tighten the belt tension
handle.
Figure-17 Belt tension handle
Once the belt is installed, perform the belt
tracking adjustment so that the belt tracks
in the center of the drums. (See page-10 for
details)
Re-install the guards, dust hood and
auxiliary table and the work-piece stop.