Craftex CX125, Руководство пользователя, Страница: 19 / 34

19
HEIGHT ADJUSTMENT SCALE
The cutterhead height relates directly to the
scale located at the front of the planer. The
measurement indicated by the red arrow on
the scale will be the thickness of the board
after planing. However the cutterhead
height adjustment scale is not a precise
measurement but an approximation.
FEEDING MATERIALS
The rate of feed is preset on this machine at
a rate of 26 FPM (Feet Per Minute). The
purpose of the infeed and outfeed rollers
are to keep the pressure on the material as
it passes under the cutterhead keeping it
flat and moving at a consistent 26 FPM.
How to Feed Material:
1.
Rest the material on the table surface of
planer with the side to be planed facing
up towards the cutterhead. Material over
2 feet should be supported at both sides
of the planer.
2. Lower the cutterhead by turning the
cutterhead height adjustment crank until
the depth bar barely touches the surface
of material to be planed.
3. To remove the recommended 1/32”
depth of cut turn the height adjustment
crank 1/2 turn clockwise.
4. Turn the planer on and with the flat side
of your material facing down slowly feed
it through the planer well standing
beside the material to reduce possibility
of kickback injuries.
5. Once the material has cleared the
outfeed roller check material thickness.
If material requires more planing turn the
height adjustment crank a half turn
before putting material back through
again to remove another 1/32”. Continue
to repeat this step until you have
reached your target thickness.