Craftex CX116, Руководство пользователя

Страница: 17 / 23

17
BLADE TRACKING
The blade tracking on the CX116 has been
properly set at the factory but we
recommend you to check and adjust it (if
needed) before turning on the machine.
To adjust the blade tracking:
Make sure the cord is disconnected from
the power source.
Hold the headstock and remove the feed
cylinder knob shown in figure-15. page-16.
Remove the safety knob shown in figure-
15, page 16 and raise the headstock to the
full vertical position.
Remove the blade guide assemblies.
Remove the wheel guard.
Loosen the lower hex bolt on the blade
wheel assembly, but do not remove it. See
figure-16.
Figure-16 Blade tracking set screw
Use a hex wrench and adjust the set screw
shown in figure-16.
Loosening the set screw will move the
blade away from the shoulder of the wheel.
Tightening the set screw will move the
blade towards the shoulder of the wheel.
The blade is tracking properly when the
back of the blade is touching the edge of
the wheel flange and it is not rubbing
against the flange.
Retighten the lower hex bolt.
Reinstall the wheel guard.
Reinstall the blade guard and blade guide
assemblies.
Adjust the blade guides as instructed on
page-14. "Blade Guides".