Craftex CX116, Руководство пользователя

Страница: 14 / 23

14
Slowly turn the feed rate dial counter
clockwise, allowing the blade to cut the
work piece.
BLADE GUIDES
The blade guides side bearings support the
blade and allow it to cut the work piece
perpendicular to the table and the support
bearings prevent the blade from being
pushed back while cutting.
To adjust the bearings:
Make sure the cord is disconnected from
the power source.
Use the proper sized wrench and loosen
the guide bearing adjustment hex bolt. See
figure-11.
Figure-11 Blade guide adjustment
Adjust the blade guide assembly so that the
support bearing touches the blade.
Now, loosen the two nuts securing the side
bearings. See figure-11.
Rotate the side bearing eccentrics until the
space between the blade and the bearing is
about 0.000" to 0.001".
Tighten the nuts.
Loosen the lock knob and slide the blade
guide close to the work piece so the blade
is supported and will not twist while cutting.
See figure-12.
Figure-12 Lock knob
WARNING!
Make sure the cord is disconnected from
the power source, before servicing or
making any adjustments.