Craftex CX104, Руководство пользователя, Страница: 23 / 31

23
CLEANING AND
LUBRICATION
The moisture from the wood dust remains
on the table surface and can cause rust.
Protect the un-painted cast iron surfaces of
the table by cleaning the dust and wiping
with a piece of cloth after every use. Apply
a protective coating after.
If the table becomes harder to tilt, remove
the table and apply a few drops of oil on the
trunnions.
V-BELT
The V-belt stretches with use, and should
be re-tensioned periodically. To ensure
optimum power transfer from the motor to
the blade, the belt must be in good
condition and under proper tension.
Check the V-belt at least after every 3
months and more often if the band saw is
used daily.
TO INSPECT THE V-BELT:
Turn the power switch off and disconnect
the cord from the power source.
Open the lower cabinet and check the V-
belt for cracks or any other kind of damage.
If the belt is damaged, it needs to be
replaced.
TO REPLACE THE V-BELT:
Lift the blade tension handle up and release
the blade tension.
Remove the table insert and the table lock
pin and open the upper cabinet.
Wear a pair of gloves and carefully remove
the blade.
Uninstall the lower wheel by removing the
hex nut securing the wheel to the saw body.
See figure-37.
Figure-37 Lower wheel and pulleys
Loosen the motor mounting nuts shown in
figure-38 and lift the motor up to remove the
belt from the pulleys.
Figure-38 Motor mounting nuts
Install the new belt and re-tighten the motor
mounting nuts.
Re-install the wheel, the hex nut, the blade,
the table insert, the table lock pin and close
the cabinets.