Craftex CX104, Руководство пользователя, Страница: 21 / 31

21
Figure-34 Crosscutting on CX104
RESAWING
Cutting a work-piece into two or more
thinner pieces is called resawing. Wider
blades give better result, when resawing.
To resaw a work-piece make sure that the
table is at a 90° with the blade and use a
wider blade for better results.
Adjust the fence according to the width of
the cut you want, and lock it in position.
Turn the band saw ON and feed the work-
piece into the blade using feed paddles until
the blade is completely through the work-
piece.
Figure-35 Resawing on CX104
CUTTING CURVES
For cutting curves always try to use
narrower blades. When cutting curves feed
the stock into the blade and turn it very
carefully so that the blade follows the line of
cut and make sure the blade does not twist.
Make relief cuts through the waste part of
the work-piece which makes the job easier
and prevents the blade from twisting.
WARNING
When installing / removing and servicing
any part of the machine, make sure the
power switch is in the off position and the
cord is disconnected from the power
source. Failure to do so may result in
serious personal injury or death.