Craftex CX08HC, Руководство пользователя

Страница: 12 / 24

12
DUST HOOD
Attach the dust hood to the side on the
stand assembly by using the hex bolts, flat
washers and hex nuts provided. See figure-
11.
Figure-11 Installing the dust hood
PEDESTAL SWITCH
To install the pedestal switch, take the
switch and attach it to the stand using the
screw lock washers, flat washers and cap
screws. There is a wire that comes from the
motor to the switch. You can pass the
excess motor wire to the stand through the
hole located in the stand. See figure-12.
Figure-12 Installing the pedestal switch
V-BELT
Your machine is provided with a V-belt that
goes around the motor pulley and the
cutter-head pulley.
To install the V-belt loosen the motor
bracket fasteners and slide the motor a little
upward. Now, put the V-belt around the
motor pulley taking it around the cutter-
head pulley. Then slide back the motor
downward and tighten the motor bracket
fasteners. See figure-13.
Figure-13 Installing the V-belt
WARNING!
This machine produces large amount of
dust. To avoid respiratory illness do not
run it without the dust collection system.