Craftex CX08HC, Руководство пользователя

Страница: 18 / 24

18
SETTING THE
OUTFEED TABLE
The height of the out-feed table must be
equal to the height of the cutter-head
knives.
To adjust the out-feed table height, first of
all disconnect the jointer from the power
source. Remove the cutter-head guard and
fence and loosen the out-feed table lock,
the jam nuts and positive stop bolts located
at the front and at the back of the machine.
Now place a straightedge on the out-feed
table so that it hangs over the cutter-head.
Lower the out-feed table until the
straightedge just touches the cutter-head
body. See Figure-24.
Figure-24 Out-feed table height with the
cutter-head body
Now, tighten the out-feed table lock and the
positive stop bolts and the jam nuts located
at the back and front of the machine. Set
the knife height to the new out-feed table
height.
SETTING THE INFEED
TABLE HEIGHT
The positive stop bolts located at the back
of the machine allows you to adjust the
height of the in-feed table.
The recommended setting for the minimum
depth of cut is 1/32” and the maximum
depth of cut is 1/8” for most of the
operations.
There are two positive stop bolts and each
bolt controls the top and bottom range of
table movement. The jam nut is to lock the
bolts in place so that they do not move
during the operation. See Figure-25.
Figure-25 In-feed table positive stop bolts
WARNING!
Do not exceed 1/8” cut per pass on the
machine or kick-back and serious injury
may occur.