Craftex CX series, Руководство пользователя

Страница: 17 / 38

17
BASIC CONTROLS
The basic controls of this machine are
shown in the figure-27. Use the figure and
read the text to understand what the basic
controls of your CX200/CX201 are.
Figure-27 Basic controls on CX200/CX201
Magnetic Switch
The magnetic switch on your CX200/CX201
has a green button to turn the machine
“ON” and a red button to turn the machine
“OFF”, when pressed.
Blade Height Hand Wheel
It is used to raise and lower the blade. The
hand wheel features a locking knob at its
center, which is used to lock the hand
wheel. If you want to adjust the blade
height, loosen the hand wheel lock and turn
the hand wheel. When the blade is at the
desired height, tighten the lock.
Blade Tilt Hand Wheel
It is used to adjust the angle of the blade.
The hand wheel features a lock in its
center, which is used to lock the hand
wheel. If you want to adjust the blade angle,
loosen the locking knob and turn the hand
wheel. When the blade is at the desired
angle, tighten the lock.
TEST RUN
Once you have assembled your machine
completely, it is then time for a test run to
make sure that the machine works properly
and is ready for operation.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates excessively, stop the
machine immediately and disconnect from
the power source and investigate to find out
the problem with your machine.
During the test run you should make sure
that the machine operates properly when
turned ON. Check all the safety features on
the machine and make sure all the safety
features work properly.
Before starting the table saw, make sure
that you have read and understood the
manual and you are familiar with the
functions and safety features on this
machine. Failure to do so may cause
serious personal injury.
READ THE
MANUAL
WARNING
The safety instructions given in this
manual can not be complete because the
environment in every shop is different.
Always consider safety first as it applies
to your individual working conditions
.