Craftex CX series, Руководство пользователя

Страница: 24 / 38

24
Figure-39 Motor mounting hex nuts
Once there is approximately 1/2" deflection
in the belts when applying moderate
pressure using your finger, re-tighten the
hex nuts.
Figure-40 Correct tension on the V-belt
REPLACING THE V-BELTS
Turn the table saw switch “OFF” and
remove the cord from the power source.
Lower the blade to the maximum and open
the motor cabinet. Loosen the hex nuts
securing the motor as shown in figure-39
and move the motor up and remove the V-
belts off the pulleys.
Install the new V-belts and onto the pulleys
and lower the motor to tension the belts.
When the belts are correctly tensioned,
tighten the hex nuts and close the motor
cabinet.
MAINTENANCE
1. The unpainted components such as the
precision-ground cast-iron table top
should be protected with a coat of paste
wax and then buffed dry.
2. Regularly vacuum all sawdust from the
saw’s interior and vacuum the motor
openings as well.
3. Check drive belts for wear and correct
tension on a regular basis.
4. Check that the blade guard and anti
kickback pawls operate properly.