Craftex CT170, Руководство пользователя

Страница: 13 / 16

13
Take the belt off the rollers with another
hand and replace it with a new one.
Once the belt is position on the wheels,
remove your hand and the let the adjusting
shaft guard to come in its normal position
and tension the belt.
Perform the belt tracking adjustment and
re-install the cover and the table.
SANDING DISC
REPLACEMENT
To replace the sanding disc:
Turn the switch OFF and remove the cord
from the power source.
Loosen the sanding disc table and the dust
chute by removing the knobs and screws
securing them to the sander.
Peel the old sanding disc from the sanding
wheel and clean the surface of the wheel.
Peel off the new sanding disc and expose
its self adhesive back and position it on the
wheel. Make sure it is on the center of the
wheel. See figure-15.
Figure-15 Installing sanding disc
MITER GAUGE
CT170 is provided with a miter gauge and
can be used on the disc table.
The miter gauge head can be set anywhere
up to 45° right or left, by loosening the lock
knob, setting the miter gauge ahead to the
desired angle and tightening the lock knob.
Figure-16 Miter gauge
MAINTENANCE
All ball bearings are sealed and
permanently lubricated and do not any
lubrication.
Check the sander for loose mounting
hardware, worn or damaged wires,
damaged abrasive belt and disc or any
other unsafe condition before each use.
WARNING
Turn the switch OFF and make sure the
cord is disconnected from the power
source before installing, servicing,
removing any parts. Failure to do so may
result serious personal injury.