Craftex CT170, Руководство пользователя

Страница: 11 / 16

11
TEST RUN
Once you have assembled the machine it is
then time to do a test run and see that the
machine powers up and runs properly.
All the tools and objects used for
assembling the machine should be
removed and cleared away during test run.
During the test run make sure the ON/OFF
button and all the safety features on the
machine are working properly.
Connect the machine to the correct power
source. Stand to the side of the grinding
wheel and start the machine. During the
test run if there is any unusual noise or
vibration, disconnect the machine from the
power source immediately. Check all the
parts you have assembled, once again and
try to find out the problem.
BELT SANDER PLATEN
The platen is a steel support plate that is
positioned behind the sanding belt, rising
from the table level to a point several
inches above the table surface. Platen
provides support to the work when sanding
and it should be adjusted so that it is almost
touching the back of the sanding belt.
To adjust the platen:
Make sure the switch is in the OFF position
and the cord is disconnected from the
power source.
Loosen the lever securing the table and
remove it to access the hex screws.
Loosen the two hex screws located under
the table, securing the platen to the sander
frame.
Adjust the platen so that it is almost
touching the back of the belt and re-tighten
the screws. See figure-10.
Figure-10 Sanding platen
SQUARING THE TABLES
A better result can be provided when the
table is at 90° with the belt/disc.
To square the table:
Make sure the switch is in the OFF position
and the cord is disconnected from the
power sources.
Loosen the lock knobs/lever securing the
table to the machine and place a square on
the table as shown in figure-11 and figure-
12.
Adjust the table so that it is square with the
belt/disc and tighten the knobs.