Craftex CT170, Руководство пользователя

Страница: 9 / 16

9
Figure-4 Installing sanding disc dust chute
SANDING DISC TABLE
CT170 is provided with a work table for disc
sanding operation.
To install the sanding disc table:
Make sure the switch is in the OFF position
and the cord is disconnected from the
power sources.
Attach the table to the sander, above the
dust chute as shown in figure-5 and secure
it using two lock knobs from both sides.
Figure-5 Installing the sanding disc table
BELT TRACKING
Belt tracking means to adjust the belt in the
center of the rollers so that it runs true and
does not wander left or right off the rollers.
The belt tracking on CT170 is very simple
and easy. The sander is provided with a
belt tracking adjustment knob as shown in
figure-6.
Figure-6 Belt Tracking adjustment knob
To adjust the belt tracking:
Make sure the switch is in the OFF position
and the cord is disconnected from the
power sources.
Remove the upper guard lock knob, the
screws holding the side cover and remove
the side cover to expose the rollers.
Rotate the sanding disc with your hand
which will rotate the sanding belt and watch
where the belt rides on the rollers.
Keep rotating the disc with one hand the
use the other hand to turn the belt tracking
adjustment knob.