©2015 Cradlepoint. All Rights Reserved.
|
+1.855.813.3385
|
cradlepoint.com
40
User Manual
/
AER3100/AER3150
Virtual Router IP:
IP Address of the Virtual Router.
Virtual Router ID:
Identifier of the Virtual Router.
Router Priority:
Failover priority of this router. The highest
priority router will take ownership of the Virtual IP.
WAN Fault Priority:
This optional value sets the failover priority
of this router when no WAN connection is available. If the value
matches the normal router priority, WAN connection state
will not be considered. If the value is empty (the default), the
router will always give up the Virtual IP and let a new master
take over when no WAN connection is available.
Advertisement Interval:
Sets the amount of time (in seconds)
between sending VRRP advertisements.
Initial Value Router State:
This controls the initial failover state
of the VRRP instance when it first comes up.
Authentication:
VRRP Authentication Method. Note that VRRP
Authentication has been deprecated as of RFC 3768.
Password:
VRRP Group Password.
Provide Virtual IP in DHCP leases:
Select this to automatically set the DHCP default gateway address and DNS
server address to the Virtual IP in DHCP leases provided on this network.
STP
Enable STP:
Enable
Spanning Tree Protocol
loop detection.
Bridge Priority:
Set the priority of the bridge. When determining the root bridge of the spanning tree topology,
the bridge priority is compared first. The bridge with the lowest priority with will win. If you want this router to
be the root bridge, then set it to a value less than the default of 32768. A valid priority value is between 0 and
65535.
Wired 802.1X
Enable 802.1X:
Require IEEE 802.1X Authorization.
Reauthentication Period:
EAP reauthentication period in
seconds.
Auth Server IP Address:
IP address of the connected RADIUS
server.
Auth Server MAC Address:
Hardware address of the
connected RADIUS server’s interface.
NOTE: If you don’t
know the MAC address for the RADIUS server, enter
00:00:00:00:00:00, and the service will try to find the MAC
address from the given IP address.
Port
Password
Acct Server IP Address:
IP address of the connected RADIUS
server.
Acct Server MAC Address:
This is the Hardware address
of the connected RADIUS server’s interface.
NOTE: If you
don’t know the MAC address for the RADIUS server, enter
00:00:00:00:00:00, and the service will try to find the MAC
address from the given IP address.
Port
Password
