CPS FX1234, Руководство по обслуживанию, Страница: 54 / 57

54
Identifier Error Codes
“00001” Error #1: The air or gas readings were unstable.

Solution: Move the unit away from sources of EMF or RFI such as radio
transmitters and arc welders.
“00002” Error #2: The air or gas readings were excessively high.

Solution: Move the unit away from sources of EMF or RFI such as radio
transmitters and arc welders.
“00003” Error #3: The air calibration resulted in a low output.

Solution: Prevent refrigerant from flowing into the unit through the sample inlet
during air calibration.

Solution: Allow any refrigerant in the atmosphere to dissipate before performing
air calibration.

Solution: Verify that the air intake and the exhaust are not obstructed

Solution: Verify that the white filter is correctly plugged into the rubber grommets.
“00004” Error #4: The unit is beyond the operating temperature range

Solution: Move the unit to an area where the ambient temperature is within the
specified operating range.
“00005” Error #5: The refrigerant sampled has an excessively large amount of air or there was
little or no sample flow due to a closed valve or plugged sample filter. This is the code to prompt
the user to change the brass filter. This should be considered more as a prompt than an actual
error.

Solution: Verify the coupler valve is open.

Solution: Verify the sample filter is not plugged with debris or oil

Solution: Replace brass sample filter

Solution: Verify that the white filter is correctly plugged into the rubber grommets.
“00006” Error #6: The air sensor has expired and must be replaced before the analyzer can be
used.
“00007” Error #7: The pressure read by the sensor has been determined to be too high.

Solution: Verify that the exhaust is not obstructed.