4096-668
CPI Satcom & Antenna Technologies 1.8M Ka-BAND Rx/Tx ANTENNA
7.
Tighten securely the three 5/16-inch bolts used to attach the feed system to the reflector and
the 5/16-inch bolt used to attach the feed rods to the feed support at this time.
8.
Tighten securely the two 5/16” bolts attaching the tailpiece to the feed support and the two
5/16” bolts attaching the tailpiece to the reflector support at this time.
Attaching the feed assembly
1.
Attach feed assembly with its’ mounting bracket to the end of the feed support with a 5/16 x
1.00” bolt and flat washer (Items #5, 7) in each of the mounting bracket holes aligning them
with the two holes in the end of the feed support.
2.
Secure with a flat washer, lock washer, and hex nut (Items #7, 8, 9) on the bottom of the feed
support. Tighten securely.
3.
Note:
Depending on the configuration of your feed assembly, it may vary in physical
appearance from the illustration below. The mounting bracket will correctly position the feed
on the feed support using the two mounting holes.
Feed Support
Feed Assembly
W/Mounting Bracket
(Item #1)
5/16” Flat Washer, Lock Washer,
and Hex Nut
2 Places
(Items #7, 8, 9)
5/16” Bolt and Flat Washer
2 Places
(Items #5, 7)
